HOW TO : INSTALL YOUR STRAPS !!!

Here is a Tutorial to install your correctly Straps for your Foil sessions. 1) Take your straps and screws. To install each strap, you need 2 three-hole plates, 2 4.8×25 screws and a Phillips screwdriver. For info: on these GONG Footstraps symmetric large light, the widest part covers your navicular bone which is the big toe. Keep this in mind for installing your straps in the right direction. 2) At each end of the strap there is a Neoprene flap under which there are 3 rows of 3 holes on the narrowest side and 4 rows of 3 holes on the widest side. This allows you to adjust the strap to fit your size as snug as possible. 3) Place your washer on the row of holes that corresponds to the desired spacing. Insert a screw in the hole in the middle of the plate and the strap. Your washer is correctly installed with the screw. 4) Place the screw facing the insert. Insert the screw in the hole of the insert according to the desired position before screwing. This will prevent damage to your pad, the Board or even the strap insert. 5) Screw your screw in tightly. For maximum efficiency, apply pressure with the hand that is not screwing on the top of the screwdriver while screwing. A good indicator of a correct screwing: the strap must not be able to turn on the screw axis, it must be immobilized. 6) Carry out the same steps seen above to fix the other part of the strap on the chosen insert. 7) Your rear strap is installed. 8) Finally, you only have to install the front straps. Note : Each time you change the position of your straps, we recommend that you change your screws. You will find all the screws and bolts for installing the straps on the online shop. Advisor : Patrice Guénolé and GONG -GALAXY.